Checking For Leaks - Outdoor Leisure PMSQSS40 Manual Del Proprietário

9. Open base door. Wrench tighten regulator
and hose assembly to manifold as shown
in Figure 10. Check connections for gas
leaks (see Checking for Leaks).
Note: Make sure hose and regulator as-
sembly attached to manifold are never
bent or kinked during installation and
operation of heater.
Connect Hose
to Manifold
Figure 10- Regulator and Hose Assembly
IMPORTANT: The heater must be leak tested
before any further assembly is done. Use only
a noncorrosive leak detection fluid. DO NOT
USE FLAME.
Turn control knob to the OFF position. Se-
curely connect regulator to propane/LP gas
cylinder. Open propane/LP cylinder valve.
Apply a noncorrosive leak detection fluid to
connections at the manifold and regulator
connections. Bubbles forming show a leak.
123748-01A
aSSEMBLy
Continued

cHEcking FOr LEakS

www.desatech.com
10. Place propane/LP tank inside of base.
Attach regulator.
11. Install propane tank safety chain around
tank and into openings in base sides.
Figure 11 - Propane Tank and Safety
In case of any leaks, turn off propane/LP
cylinder valve, remove manifold, check and
clean connection. Reconnect manifold and
leak test again.
Upon completion of leak test, and when
there is no sign of a leak, turn off propane/LP
cylinder valve and disconnect regulator from
propane/LP gas cylinder. Remove propane/LP
gas cylinder and continue to next step.
Safety
Chain
Chain
7