Tabla de contenido
Idiomas disponibles
Idiomas disponibles
(Please skip this section if you have no cable connected
to the Antenna
input of the TV.)
_[_ When the TV is powered-on
for the first time you will be prompted
to auto install the TV in order to receive the channels to receive the
channels that are broadcasted
locally.
Note - The TV will take approximately
10-15 seconds to start up.
O
Select the desired Language
and press the green button
"Next".
Select Cable
or Antenna
in the Installation
mode and press the green button
"Next".
Auto
Installation
may take 20 to 40 minutes
depending on the number of channels that are transmitted
by the cable provider
or
broadcaster.
When
the TV is not receiving any signal from the antenna/cable,
the message CHANNEL
NOT
AVAILABLE
will appear on the TV
screen. When
no transmission
is received from the broadcaster,
a BLANK
SCREEN
will appear on the TV screen.
Note - The TV will go on to standby after 10 minutes.
Press the POWER
button
on the remote
control
to on the TV.
O
You will not be able to receive pay channels when using direct antenna/cable
connection
to the television.
When
the Set-top box is connected
to the television
using coaxial cable, it is necessary to auto-program
the television
for the single channel
(3 or 4) that the Set-top box outputs
and change the channels at the Set-top Box (using the set-top
remote
control)
to view the program.
Refer to the manual for more details.
Note - The newly installed channels maybe sorted
in a deifferent
sequence on this TV. Please key using the CH +/- buttons to get to know
the new channel. Also you can use the OK key to see the list of channels.
Q
When
the Set-top
box is connected
to the television
using one of the AV connections
(AV1/AV2/AV3/HDMI),
select that
input source
(using the AV+ button)
to view the programs
and change
the channels
at the Set-top
Box (using the set-top
box remote
control)
to view the
program.
_ii_ Multimedia
browserj
_)
Plultimedia
browser
lets you display pictures
or play audio files stored
on a
USB device.
The Multimedia
browser
application
is invoked from the Ply Content
menu
(press the O_
button)
by selecting the USB device and pressing the cursor
right.
Notes:
- Following file formats can be reproduced:
• For pictures: jPEG
• For auclio: MP3, MP3 Pro
- Only FAT/DOS-_brmatted memory devices are supported.
- If your digital camera is not supported, make sure your camera is switched on and
venlq/ if its configuration settings are correct (see the manual of your camer_J).
- Philips cannot be responsible if your USB device is not supported,
23
Tabla de contenido
