Mounting The Camera - D-Link DCS-6212L Guía De Instalación Rápida

MOuNTING THE CAMErA

Please refer to the steps below to assist you with mounting the camera. We suggest that you
configure the camera and insert a microSD card(if desired) before mounting.
DCS-6212l
Step 1:
Use the included wrench to loosen the 3 screws on the top of the
camera, then lift the camera cover off.
Step 2:
Place the camera in the position you want and use a pencil to mark
the holes. Ensure the camera is oriented correctly with adequate
space for the necessary cables to be routed.
Step 3:
Depending on the material of the wall or ceiling, use proper tools to
drill two holes 25mm deep with a 6mm drill bit where you marked.
After drilling the holes, insert the plastic anchors to support the
screws.
If you are running the camera cables through the wall, drill a
hole in the center and pull the cables through the hole.
Step 4:
If you are using PoE to power the camera, use a small Philips
screwdriver to remove the screws for the power connector cover,
then disconnect the power cable.
Place the power cable plug into the gap, then reattach the cover with
the screws.
5