Mounting The Camera - D-Link DCS-4712E Guia De Instalacion

Mounting the Camera

Note: It is highly recommended that you
configure and test your camera before mounting
it. If you plan on inserting a microSD card, it is
also recommended to do this before mounting.
1. Place the alignment sticker where you
want to position the camera. Make sure
the camera base will be positioned so
that the cable channel is on the bottom.
2. Use a 4 mm drill bit to make the required
holes approximately 30 mm deep, then
insert the wall anchors into the holes.
Figure 9: Attaching the Wall Anchors
3. If you are running the camera cables
through the wall, drill a hole in the center
and pull the cables through the hole. If you
are running the camera cables out the side
of the camera, guide the camera cables
through the cable channel on the base.
4
Figure 10: Securing the Cables
4. Use the screws provided to mount the
camera to the wall.
Figure 11: Securing the Camera
5. Connect the power and Ethernet cables,
or just the Ethernet cable if you are using
a PoE connection.
Figure 12: Connecting the Cables
6. To adjust the camera's monitoring
direction, use the Allen key to turn the
adjustment screw counterclockwise to
loosen it, then move the camera to the
desired position and angle. When you
are finished, turn the adjustment screw
clockwise to tighten it.
Quick Installation Guide