Dimplex BLF50 El Manual Del Propietario página 11

Fireplace Installation
5. Unscrew the two wire connec-
tors inside the electrical box
and separate the wires (Figure
5).
6. Remove the one Phillips screw
that attaches the junction box
cover to the fireplace chassis
(Figure 5) from inside.
7. From the back of the fireplace,
remove the remaining three
Phillips screws which hold the
junction box to the fireplace
chassis (Figure 6).
8. Pull the junction box and
power cord out the front of the
fireplace.
9. Replace removed junction box
cover with the supplied hard-
wire cover replacement (Fig-
ure 7) and install using screws
removed in steps 6 and 7.
10. Leaving a minimum of 3 in.
(7.6 cm) of slack, route the
power supply through the hole
in the alternate junction box
cover and secure with a wire
clamp (not supplied).
11. Connect the black wire (live)
from the unit to the black wire
from the power supply using
one of the wire connectors
removed in step 5 (Figure 8).
Figure 8
Black live
wires
White neutral wires
Figure 7
12. Connect the white wire (neu-
tral) from the unit to the white
wire from the power supply us-
ing the second wire connector
from step 5 (Figure 8).
13. Attach green grounding wire
to hard wire cover cover with
provided grounding screw.
Place wire in-between screw
and lock washer and tighten.
14. Reposition the electrical box
Wires to
controls
Hole for
Ground Screw
11