Technical Data; Safety; Safety Notices - LIVARNO LUX 302484 Instrucciones De Montaje, De Uso Y De Seguridad

Lámpara led de techo
Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

Wall plugs
9
Mounting bracket
10
Locating screws (terminal housing)
11
Screws (mounting bracket)
12
Lustre terminal
13
Mains connection cord (external)
14
Protective tube
15

Technical Data

Item number:
14130102L
Operating voltage: 230 - 240 V ~ 50 Hz
Rated output:
2 x LED 5 W
Protection class:
I
Protection type:
IP20

Safety

Safety notices

Damage due to failure to comply with these operat-
ing instructions will invalidate the warranty! We assume
no liability for consequential damage! We assume
no liability for material damage or personal injury
due to improper handling or failure to comply with
the safety instructions!
Do not leave the light or packaging material ly-
ing unattended. Plastic film or bags, plastic parts,
etc. can be dangerous for children to play with.
Avoid the risk of fatal injury
from electric shock
Ensure that a qualified electrician, or a person
trained to carry out electrical installations, per-
forms the electrical installation.
Always check the light, power supply, and mains
cable for damage before plugging it in. Never
use the light if it shows any signs of damage.
A damaged mains cable indicates a life-threaten-
ing danger due to electric shock. In the event
of damage, repairs or other problems with the
Introduction / Safety
light please contact the service centre or a
qualified electrician.
Prior to installation, remove the fuse or switch off
the circuit breaker (0 setting) in the fuse box.
Prior to installation, verify the available mains
voltage corresponds with the operating voltage
required for the light (see „Technical Data").
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the light on a wet or conductive
substrate!
The connecting leads must be covered with the
included rounding wires.
Prevent fire and
injury hazards
RISK OF INJURY!
Check each lamp and lamp glass for damage
immediately after unpacking.
Do not mount the light with defective lamps
and / or lamp lenses. Should this be the case,
contact the service centre for a replacement.
Do not look directly into the light source (lamp,
LED etc.).
CAUTION! RISK OF BURNS
DUE TO HOT SURFACES!
Ensure the light has been switched off and has
cooled before touching it to avoid burns. Lights
develop a lot of heat around the lamp head.
Allow the light to cool off completely.
The illuminant in this light must be replaced by
the manufactured or an authorised technician
or similarly qualified person.
Safe working
Mount the light so that it is protected from mois-
ture and dirt.
GB/MT
25
Tabla de contenido
loading

Tabla de contenido