Scope Of Delivery; Parts Description; Technical Data; Safety - LIVARNO LUX 14109500L Instrucciones De Montaje

Scope of delivery

Check immediately after unpacking that the parts
are complete and that the product is in proper con-
dition.
1 LED rope light
2 connectors
4 end caps
2 cable holder
1 adhesive strip
1 set of instructions for use

Parts Description

Mains adapter
1
Supply cable
2
LED strip
3
Plug connection
4
End cap
5
Cable holder
6
Adhesive strip
7

Technical Data

Item No.: 14109500L and 14109606L
LED Strip:
Operating voltage: 220 - 240 V ~ 50 / 60 Hz
14109500L: max. 7 W, 96 LED,
max. length 3 m
14109606L: max. 9 W, 90 LED,
max. length 3 m
Protection class: II /
Protection type: IP20
LED non-replaceable

Safety

Safety instructions

Damage due to failure to comply with these instruc-
tions for use will void the warranty! We assume no
liability for consequential damages! We assume no
liability for property damage or personal injury
due to improper handling or failure to comply with
the safety instructions!
Avoid the risk of fatal injury
from electric shock
Check the LED strip for damage before every
use. Never use the LED strip if any damage is
detected.
A damaged mains cable poses
a risk of fatal injury from electrical shock. In the
case of damage, repairs or other problems,
please contact the service centre or a qualified
electrician. The supply cable of this appliance
cannot be replaced. If the cable is damaged,
the appliance must be disposed of. The appli-
ance contains no parts which may be serviced
by the consumer.
Make sure before use that the available supply
voltage corresponds to the required operating
voltage of the item (see "Technical Data").
Never allow the live power leads and contacts
to come into contact with water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the lamp on damp or conductive
surfaces.
This LED strip must not be connected electroni-
cally with other LED strips.
Protect the product from sharp edges, mechani-
cal loads and hot surfaces.
Do not secure with sharp staples or nails.
Always unplug the mains plug from the socket
before assembly, disassembly or cleaning.
Never catch hold of the mains plug or the LED
strip with wet hands.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
This item must not be connected with the power
supply while it is still in its packaging provided
that the packaging has not been adjusted for
exhibition purposes. Lay out the item completely
before you connect it to the power supply.
Introduction / Safety
GB/IE 13