Commissioning The Device; Charging The Battery - ProMed ARP-5.4 Instrucciones De Empleo

COMMISSIONING THE DEVICE

Before getting started, please check that the delivery is complete.
Make sure that the battery-operated neck-and-back heating pad does not get stuck.
Please use original parts only!
Please do not use any other battery or power adapter!
Attention
Please ensure that the battery-operated neck-and-back heating pad is not too tight so that some air
can circulate between the neck-and-back heating pad and your skin when using it. Under all
circumstances, avoid accumulation of heat.
Under all circumstances, avoid accumulation of heat.

Charging the battery

Always insert the male power adapter connector (B) into the female power adapter connector(C) on
the battery first, before you insert the power adapter (A) into a socket.
DE
Always charge the battery in the control element at room temperature.
Make sure that you do not fall asleep during use. If you become very tired during use, sellect setting
1 for safety.
EN
The back heat pad is not a medical product.
The battery in the control element must be charged for at least 3-4 hours before it is used for the first time or after
FR
it has not been used for a longer period of time.
To do this, please proceed as described below:
1. Insert the male power adapter connector (B) into the female power adapter connector (C) on the battery.
IT
2. Insert the power adapter (A) into the power socket.
3. Press the ON/OFF temperature button (F) several times if necessary until the battery status indicator (D)
flashes blue. As soon as the battery has been charged completely, the blue indicator goes out. The charging
takes a maximum of 5 hours.
ES
4. Remove the power adapter (A) from the power socket and disconnect the power adapter from the battery.
If the battery is already empty, the heating pad can also be operated with the power adapter connected.
NL
Using the battery-operated neck-and-back heating pad with a power adapter (Direct-Drive)
1. Insert the male power adapter connector (B) into the female power adapter connector (C) on the battery.
2. Insert the male heating pad connector (J) into the female heating pad connector (H) on the battery.
3. Insert the power adapter (A) into the power socket.
RU
4. After use, remove the power adapter (A) from the socket.
If the battery-operated neck-and-back heating pad has not been used for a very long time, the battery may have
discharged to the point that the heating pad can no longer be operated only by using the power adapter. In this
PL
case, you must first charge the battery.
Commissioning
1. Place the battery-operated neck-and-back heating pad on your shoulders. The battery bag (K) faces
SE
outwards. Close the snap buttons (L) and fasten the hip belt (I) in such a manner that the battery-operated
neck-and-back heating pad remains in its position, but can still be worn comfortably and that the belt is not
too tight.
FI 2. Connect the battery to the battery-operated neck-and-back heating pad.
3. Press the ON/OFF temperature button (F) several times if necessary to switch on the heating function. The
indicator lights 1 – 4 (E) indicate the heating level set; here, the light above the heating level set lights up