General Instructions; Connection To The Mains - Tecnoinox PF_X105VE7 Manual De Instrucciones

ELECTRIC COOKERS WITH ELECTRIC OVEN

General Instructions

The appliance referred to in this manual has been manufactured in conformity to
the following Directives: 2006/96/CEE "Low Voltage"; 2004/108/CEE
"Electromagnetic Compatibility. The appliance must be installed by a qualified
technician according to the regulations and directives in force in the country
where it is installed, as well as the instructions in this manual. This appliance
has been designed exclusively for cooking food. Remove the packaging from the
appliance as well as the protective plastic sheet, and, if necessary, remove
traces of glue with a suitable solvent. To dispose of the packaging, follow local
directives.
When installing the appliance, the following regulations must be
observed:
Applicable national laws in force;

Regional and/or local regulations, such as building codes;

Directives and regulations of the local electricity board;

 Accident prevention regulations in force;
Fire prevention regulations;

Switch the appliance off in the case of a failure or malfunction.

Connection to the mains

Before connecting the appliance note the specifications necessary for the
installation: voltage, frequency, number of phases and power on the data plate
of the appliance.
The self adhesive polyester data plate is behind the panel
"T"(fig.2).
The installer must make the connection after having installed a main switch,
which is easy to reach and disconnects every pole supplying electrical power to
the appliance. The switch supplying electrical energy to the appliance must have
a minimum distance of at least 3 mm between the poles when the contacts are
open.
THE CABLE:
Must not be installed near heat sources, the ambient temperature of the

surrounding environment must not rise to over 50°C.
Must be protected by a rigid metal or plastic tube

Must at least meet H07 RN-F standards.

Must have the minimum section indicated in the table.

Part 1 - Installation
To use the appliance correctly follow the warnings below:

The appliance must never be left unattended when it is being used!

 The appliance is designed for professional use and therefore should only be
used by qualified personnel.
 Care must be taken when using the appliance because the cooking surfaces
are very hot.
The appliance should be installed under an extractor fan for removing

cooking fumes.
If the appliance is installed in line:
Respect a minimum distance of 80mm between the appliance and any walls

made of flammable material, partitions, kitchen furniture or nearby
equipment.
The surfaces in contact with the appliance must be covered with non-

combustible heat insulating material.
The appliance, and especially the power lead, must not be installed

anywhere near heat sources.
The temperature of the environment in which the appliance is installed must

not rise above 50°C.
To reach terminal board "M" (fig.2), remove the control panel "H" (fig.2) by
loosening the screws on the lower part of the panel. Following the indications in
the wiring diagram, connect the wires of the power cable to the terminal board.
The appliance must be connected to a good earth. There is a screw marked with
the symbol near the terminal board where the earth conductor should be
connected. Hold the power cable in place on the bottom, blocking it in place
with the relevant cable clamp "Q" (fig.2). The appliance must be connected to a
good earth. The appliance must also be connected to an equipotential earth.
Connect the earth with the screw marked
The equipotential wire must have a section of 10 mm
GB / IE - 1
on the rear panel of the appliance.
.
2