Vissani QR272S Manual Del Usario página 12

Installation (continued)
- Align the bracket against the side edge of the 30 in
(762 mm) cabinet and the back wall . Draw a line along
inner edge of the bracket as shown in fig. 16-1.
- Slide the bracket inwards and align it against the marked
line . Ensure the rear edge is tight against wall as shown
in fig. 16-2.
- Use a pencil to mark the location of the 3 center holes as
shown in fig. 16-3.
- Set the bracket aside and drill three 7/64" holes in the
marked locations as shown in fig. 16-4.
- Secure the bracket to the cabinet using a Phillips
screwdriver and 3 supplied countersunk wood screws
(EE) as shown in fig. 16-5.
Repeat the above procedure to install the remaining flat
bracket on the opposite side of the cabinet .
QR272S / QR272BS
EE
12
Center Line
15 in
(381 mm)
Fig . 16-1
Fig . 16-2
Fig . 16-3
7/64"
Fig . 16-4