Vissani QR272S Manual Del Usario página 11

Installation (continued)
NOTE:
This range hood can be installed to the cabinet with or without the use of the
supplied installation brackets.
A . INSTALLATION WITHOUT MOUNTING BRACKETS
If you are installing this range hood to a framed cabinet install a 3
inch wide spacer on either side of the cabinet to fill the void so that
the range hood can be securely tightened to the cabinet .
Lift the range hood (A) up under the cabinet to determine its final
position . Mark the location of the four keyhole mounting slots (1) on
the underside of the cabinet .
- Set the range hood (A) aside on a protective surface .
- Drill four pilot holes in the locations that you marked .
- Screw the four long tapping screws (AA) into the pilot holes .
Do not tighten the screws all the way – leave the screw
heads about 0 .28 in (7 mm) from the cabinet surface .
- Lift the range hood (A) into position, feeding the power
cable and the electrical wires through the power access
opening . Allow some slack in the cable and wires so that the
appliance can be moved if servicing is ever necessary .
- Position the range hood (A) so the large end (2) of the
keyhole mounting slots (1) are over the screws (AA) . Then
push the range hood (A) toward the wall so the screws (AA)
are in the neck (3) of the keyhole slots . Tighten the screws
(AA) . Ensure that the range hood (A) is securely fastened to
the cabinet before releasing it .
- If applicable, test the damper to ensure it rotates up and
down freely .
- If applicable, connect the duct work to the range hood (A) .
Seal the joints with duct tape to ensure an airtight fit.
B . INSTALLATION USING 1 PERSON INSTALL BRACKETS
B .1 FRAMELESS CABINET BRACKET INSTALLATION
- Refer to the marking on brackets to determine the correct
installation side and orientation .
- Flat end of the bracket with the arrow should face towards
you and the notched end should face the wall .
Please contact [email protected] or 1-888-449-9197 between 8:30 am - 5 pm, EST, Monday - Friday for further assistance.
DANGER:
Turn off the power circuit breaker or the
power switch on the junction box before installing this
unit . Touching circuitry inside the range hood while it is
energized will result in death or serious injury .
DANGER:
If installing this unit over a gas range, turn off
the gas at the source before installing or servicing this unit .
11
Fig . 14
Fig . 15