Care And Maintenance Of Cordless Tools - Hilti HDE 500-A22 Manual De Instrucciones Original

1. Set the dispenser volume regulator switch to
2. Squeeze the trigger until the mixing nozzle is completely full.
3. Set the dispenser volume regulator switch to the appropriate volume of mortar
◁ 1 = 1 stroke (approx. 5 ml)
◁ 15 = 1 stroke (approx. 75 ml)
4. Discard the initially dispensed volume of mortar.
5.7 Injecting mortar
Fit a new mixing nozzle for each use. Failure to observe this point will result in too little mortar being
dispensed.
1. Press the trigger.
2. Inject the mortar.
5.8 Removing the foil pack holder and foil pack
1. Set the dispenser volume regulator switch to
2. Press the release button.
3. Pull the piston rods back as far as they will go.
4. Swivel the foil pack holder up.
5. Remove the foil pack.
6. Remove the foil pack holder from the dispenser.
5.9 Removing the cartridge
1. Set the dispenser volume regulator switch to
2. Press the release button.
3. Pull the piston rods back as far as they will go.
4. Swivel the cartridge upwards.
5. Remove the cartridge from the dispenser.
6

Care and maintenance of cordless tools

WARNING
Risk of injury with battery inserted !
▶ Always remove the battery before carrying out care and maintenance tasks!
Care and maintenance of the tool
• Carefully remove stubborn dirt from the tool.
• Clean the air vents carefully with a dry brush.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
Care of the Li­ion batteries
• Keep the battery free from oil and grease.
• Use only a slightly damp cloth to clean the casing. Do not use cleaning agents containing silicone as
these may attack the plastic parts.
• Avoid ingress of moisture.
Maintenance
• Check all visible parts and controls for signs of damage at regular intervals and make sure that they all
function correctly.
• Do not operate the cordless tool if signs of damage are found or if parts malfunction. Have the tool
repaired by Hilti Service immediately.
• After cleaning and maintenance, fit all guards or protective devices and check that they function correctly.
6 English
Printed: 27.03.2018 | Doc-Nr: PUB / 5142532 / 000 / 04
7
.
9
.
.
8
.
2017693
*2017693*