Festo HSP Serie Instrucciones De Utilizacion página 48

HSP−...
Please note
For the type HSP−...−...WR/WL: Please observe the warnings and instructions in
the operating instruction for the BWR−/BWL−HSP−...
Pressurize the add−on components. If necessary, carry out a separate test run
S
to check that the add−on components are functioning correctly.
Add−on components
Without work load
With work load
Pressurize the drive in one of the following ways as desired:
S
slow pressurization of one side
simultaneous pressurization of both sides with subsequent exhausting of
one side.
Please note
Swivel module DSM−... for HSP−...−AP may only be commissioned in unmodified
state as at delivery and with protective cap.
Please note
S Start first of all a test run at reduced operating speed.
S Accelerate in steps until the operating speed is reached. For this speed,
please refer to the calculations for your application.
S Interrupt the test run if:
there is a metallic knocking of the stop screws
the double rollers do not run smoothly in the path guide
the end positions are not reached
the work load falls down.
For eliminating faults, please refer to the information in chapter 12.
48
Tests
Correct assignment of the compressed air
connections
Gripping speed
Function of the proximity switches
Reliable holding of the work load
Festo HSP−... 0308 NH English