Andis AGCB Manual De Instrucciones página 4

12. Oil blades frequently. Blades may become hot
during use.
13. Keep the appliance dry.
14. The appliance is intended for trimming purposes
only.
SAVE THESE INSTRUCTIONS
OPERATING INSTRUCTIONS
Plug cord into electrical outlet, operate 100-240 volt, 50-60 cycle AC electrical
current or as noted on unit.
UNIVERSAL AC/DC POWER ADAPTER
The unit is equipped with a universal AC/DC power adapter (Figure A.
Interchangeable input plugs are included for use in most countries around the world
(Included plugs may vary by model). See Figures B-F.
INSERTING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Insert tabs on top of plug into slots on power adapter (Figure G).
3. Push lower half of plug towards power adapter until it snaps into place.
REMOVING INPUT PLUG:
1. Unplug AC/DC power adapter from wall outlet.
2. Push up on tab on bottom of plug until plug releases from adapter.
Your Andis clipper is equipped with two cutting speeds. The speeds are adjusted
using the slide switch actuator on the top of the unit (Figure H). Setting "O" indicates
the off position, Setting "1" is low speed and Setting "2" is high speed. After using
your Andis clipper, rewrap cord and store in a safe place.
REMOVING BLADE SET
release mechanism under blade hinge (Figure I). While holding down the blade
release mechanism, push down on blade, then gently pull the blade forward (Figure
J) and slide it off the blade hinge. If your blade hinge should snap closed and is flush
with the clipper, use a small standard screwdriver to pry the tongue of the hinge out
(Figure K). NOTE: Hair may accumulate in the front cavity of the housing under the
blade. If this happens, you can clean out the hair by brushing out the cavity with a small
brush or an old toothbrush while the blade is off the clipper.
4