Removing Star-Type Centering Guides; Installing The Seesnake; Compact, And Flatpack Ball-Type Centering Guides - Ridgid Kollmann SeeSnake FlatPack Manual Del Operador

Kollmann
easiest if you place the closed portion of the c-ring
into the groove and work toward the open end. See
Figure 22.
Figure 22 – Press the c-rings into the grooves on the
centering guide. Make sure the openings in
the c-rings are 180 degrees opposite the
opening in the pipe guide.

Removing Star-Type Centering Guides

1. Pry off each c-ring with the tip of a flat blade screw-
driver inserted near the open end of the ring and
the base of the spikes. See Figure 23.
Figure 23 – Place flat tip of screwdriver between c-ring
and base of spike and pry c-ring out of
groove.
2. Slide the c-rings and centering guide over the camera
head.
If further assistance is needed, please call the Ridge
Tool Company, Technical Service Department at (800)
519-3456. Replacement guides can be ordered from
your RIDGID/Kollmann dealer.
12
SeeSnake ® FlatPack and Color FlatPack
Open Side of Guide
Ridge Tool Company

Installing the SeeSnake

FlatPack Ball-Type Centering Guides
Ball-type centering guides consists of two halves that are
pre-assembled at the factory, and two steel clips that
hold the guide in place on the spring.
Figure 24 – Centering guides improve vision by allow-
ing the camera to see an equal amount of
pipe wall in all directions and by raising the
camera out of sludge. They also reduce
wear on the LED window.
Retaining Rings
Locked
Figure 25 – Retaining Rings in Locked Position
Retaining Rings
Unlocked
Figure 26 – Unlock Retaining Rings by pulling them up
with a flat-bladed screwdriver.
® Compact, and