Transportation & Storage - Ridgid Kollmann SeeSnake FlatPack Manual Del Operador

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Kollmann
Do not clear obstructions with the camera head!
This may cause premature failure to your camera
head. The SeeSnake
®
is a diagnostic tool that iden-
tifies problems. It should never be used to clear
obstructions. Other tools should be used to make ef-
fective repairs. (See Figure 15.)
Figure 15 – Do Not Clear Blockage with Camera Head
If local 120V (or 230V) AC power for the CCU is not
available, you can operate the system using a volt-
age converter that plugs into your vehicle's cigarette
lighter. They convert your vehicles 12 volt DC to 120
volts (or 230V) AC.
The system can travel through multiple 45 and 90
degree bends and wyes. Do not, however, try to
force it through a P-trap or Tee if there is a large
amount of resistance.
Be careful in Tee-entries not to fold the camera
back on itself, this could cause the camera to get
caught. (see SeeSnake Tips & Tricks video).
The camera head can get HOT!
CAUTION
When finished with your inspection, or if taking
a prolonged break in the middle of the inspection,
turn off the system. If the camera sits in a pipe, or any
enclosed environment, heat will build-up. This may lead to
the camera head overheating which will cause fuzzy
lines to appear on the monitor. In the event this hap-
pens, turn off the system, remove the camera from the
pipe (or enclosed environment) and let the camera head
cool for 10 to 15 minutes. Running water into the line will
also help cool the camera head. Always use the minimum
illumination required to maximize picture quality and to
avoid excessive heat build-up.
Ask customers what is in the line, or what the line is
used for, prior to putting the camera into the line.
Avoid lines containing harsh solvents, chemicals, an
electrical charge and excessive heat.
10
SeeSnake
®
FlatPack and Color FlatPack
Ridge Tool Company
NOTE! See the Video Tape that came with your system
for valuable Tips and Tricks on how to handle
different situations.
Transportation & Storage
The FlatPack can be laid on its back, set upright, or hung
by its handle during transport and storage. The
Interconnect Cord should always be disconnected from
the CCU and wrapped snugly around the storage hooks
on the drum. For temporary storage at the jobsite the
camera head can be tucked inside the cone (Figure
16) For transportation and storage between jobs the
camera head should be pushed down through the cone
and into the drum to protect the camera and prevent the
spring from taking a set (Figure 17).
The Monitor Pack should always be transported and
stored with the Interconnect Cord disconnected. Care
should be taken to secure the Monitor Pack so it does
not get thrown around during transport, and so that
other equipment does not fall on it. Store the system in
a cool, dry, shaded place.
Figure 16 – Camera Head Stowed Inside Cone
Figure 17
Tabla de contenido
loading

Este manual también es adecuado para:

Seesnake color flatpack

Tabla de contenido