Replacement Filter Assembly; Important - RIDGID WD1450 El Manual Del Propietario

SP6542 14 Gallon

Replacement Filter Assembly

1. Carefully slide the filter over the filter
cage, sliding it over the center ring
covering the 3 slots until the filter stops
against the lid.
2. Place filter nut and filter plate onto
threaded stud and tighten it down.
Finger tighten only.
NOTE: Lever of filter nut should be away
from plate as shown.
IMPORTANT: Do not overtighten as this
may deform or crack the filter cage, or
filter.
NOTE: If filter cage needs to be removed,
because the float is placed in the wrong
way, use a flat blade screwdriver and
insert the blade near one of the tabs
between the filter cage and the center ring
of the lid. Pry the tab out of the slot. Tilt the
cage and lift away from the lid. To replace,
follow the assembly instructions below:
WARNING: For your own safety,
never connect plug to power source
outlet until all assembly steps are
complete and you have read and
understood the safety and operation
instructions. Do not operate vac with
any parts damaged or missing.
1. Place the float over the opening in the
center of the lid with the words "This
Side Towards Lid" laying face down over
the hole.
WARNING: To avoid personal injury
or damage to vac be sure to keep
hands, fingers, or any other foreign
objects out of the center opening
when assembling the float .
2. Line up filter cage tabs with slots in the
center ring of the lid.
3. Push on the filter cage until the tabs
snap into slots for a secure fit.
9/7/04 1:31 PM Page 6
Filter Nut
Lever
Filter Cage
Tabs (3)
Float
Solid End
THIS SIDE
TOWARD LID
Filter Cage
Tabs (3)
Slots (3)
6
Filter Nut
Filter Plate
Filter
Threaded Stud
Filter Cage
Slots (3)
Power Head
Assembly
Slots (3)