Lenco LS-100 Manual De Usuario página 7

SET UP
An AC/DC adaptor with an output of 12V DC 2.0A is included with this Turntable with Bluetooth reception and Wooden
Speakers. The adaptor is required for operating the unit.
Connect the speaker cables from each speaker to the back of the unit
Note: The external speaker cables are color coded, the cable with the red connector should be put in the red hole and the
white one in the white hole.
Firmly and securely insert the DC plug of the adaptor to the DC IN Jack on the back of the unit.
Plug the adaptor's AC plugs into a power outlet rated at 220-240V AV ~ 50 Hz.
Turn on the unit by the POWER/VOLUME Knob. The Power Led Light Indicator will turn on.
Remark: To avoid Larsen effect or Feedback noise, you can do the following:
1. Put your speakers at minimum distance of 60 cm or more from your turntable
2. Let the dustcover open when you play a record at higher sound volume
Power On and Mode selection
Turn on the unit by the POWER/VOLUME Knob. You will hear an indication sound, meaning that it is in Bluetooth mode.
Once you place the tone am on the vinyl, the turntable will switch to vinyl mode and Bluetooth mode will automatically be
disabled; Place the tone arm back to the arm rest to switch back to Bluetooth mode.
2. Listen to a Record
1. Raise the dust cover
2. Turn on the unit by the POWER/VOLUME Knob. The Power Led Light Indicator will light in RED.
3. Place a record on the turntable platter and set the player speed to match the record speed.
Note: When playing a single (a 45 rpm record) and/or records with large centre holes, use the 45 rpm adaptor.
4. Remove the needle cartridge protective cover
Unlock the tone arm lock from the tone arm rest. Push the lift lever backward, the tone arm will gently rise up. Gently
move the tone arm to the desired position over the record and the turntable platter will begin to rotate when the arm is
moved towards it If Auto Stop Control Switch in ON. Release the tone arm onto the turntable by pushing the lift lever
forward and the vinyl record will begin to play.
If the Auto Control Switch is turned ON, the record will stop automatically when finished. If Auto Stop Control Switch is
turned OFF, the record will NOT stop automatically when finished; you must push the lift lever backward to raise the tone
arm and place it back in the rest and then turn off the power to stop the turntable from spinning.
Remark: AUTO STOP function applies to most 33RPM vinyl records. However, for very few vinyl records, it will stop when it
does not come to the end, or it will not stop when it comes to the end when AUTO STOP is ON.
NOTE: If your record stops before the last track finishes, set the AUTO STOP switch to OFF. Your record will now play to the
end, but you will have to stop the turntable rotation manually.
NOTE: Depending on the record length, AUTO STOP may be enabled before the end of the recording. Do not rely on AUTO
STOP alone to turn off playback.
3. Listen to Bluetooth
An external device with Bluetooth Connectivity like a smartphone or tablet be wirelessly connected to this Turntable using
the Bluetooth function.
7