Arneg BREMA 5 Manual De Instrucciones página 40

Brema5 - Brema LF
English
15 A) Remove the plugs that seal the frame
holes;
B) Position the previously prepared plate
in correspondence with the frame holes
16 A) Remove the upper plaque in nylon
from the cabinet riser.
B) Using a bit of max 9 mm, drill in
correspondence with the predisposed
hole on the left side, so as to create a
housing for the pin of the upper hinge
Avoid off-axis or inclined holes.
Drilling depth: min.18 mm max 24 mm.
C) Re-position the nylon plaque in its new
position using the respective screws
17 At this point, re-mount the now left-
handed door, making sure to first insert
the upper hinge in the hole previously
created and to subsequently position it
slowly in such a way as to insert the lower
pin in the respective hole of the lower
plate unit.
As in dismantling, if difficulties are
encountered.
18 Restore the electric connection, taking
care to rotate the plaque (1) by 180° so
that the words "left door" appear on the
upper part of the plaque itself.
A) Close the connector;
B) Re-insert the cable;
C) Tighten the screws (1)
19 Insert the spring-loading spanner into one
of the holes of the lower pin, rotate in an
anti-clockwise direction so as to insert the
loading pin. When the operation has been
completed, the door should close
automatically. If it is not sufficiently
loaded, move the loadingpin by one hole
40
A
(1)
A B
B
C
(1)
05060047 03 24/02/2010