Glomex DISCOVERY S460S Manual De Instrucciones página 61

1. In case of use with still vehicle, park the vehicle
in an obstacle-free area.
2. Turn on the receiver and the TV set. For details
about the use of the receiver and the TV set,
please refer to the relevant user manuals pro-
vided by the relevant manufacturers.
3. On the control unit, by means of the relevant
selector (A), select the desired satellite (ASTRA
1, ASTRA 2, HOTBIRD).
4. Turn on the control unit (set (B) key to ON).
5. After a few seconds, the led (C) turns red, and
this means that the antenna is searching for the
signal.
6. If the antenna has found a satellite signal, the
led turns orange and starts checking that the
found satellite is the selected one. Verification
can take up to 30 seconds.
7. If, after a few seconds, the led turns green, it
means that the found satellite is the correct
one. Otherwise, the led turns red again, and the
satellite searching procedure is restarted.
8. With green led, after a few seconds, the image
will appear on the TV set. Follow the instruc-
tions appearing on the screen to set the param-
eters for a correct operation of the receiver.
9. Automatic stand-by function (applies to
S460M):
once the satellite has been verified (green led
on the control unit), after about 2 minutes that
the vehicle did not move, the antenna stops in
the position where signal reception from the
satellite is maximum.
A level decrease of the received signal or a total
shift of the vehicle of 6° in 2 minutes "wake the
antenna up" in order that it recovers the maxi-
mum receivable signal level.
www.glomexmobile.com
S
WARNING
If the led flashes alternately red and green, this
means that the antenna is not connected to the
control unit or that a failure has occurred. See
section "Troubleshooting" or contact the Serv-
ice Centre.
Fig. 25
A. Satellite selector
B. Power on key
C. Led
59
DISCOVERY S460S
EXPLORER S460M