Glomex DISCOVERY S460S Manual De Instrucciones página 52

DISCOVERY S460S
EXPLORER S460M
8. Mount the coaxial cable onto the antenna:
- make sure that the cable core is correctly
inserted in the central hole of the female con-
nector on the antenna (otherwise, there would
be a short circuit and the fuse installed on the
power supply line inside the control unit would
trip, see page 66 for fuse replacement);
- manually screw in the ring nut of connector F;
- once the ring nut has been manually screwed
in, tighten by ¼ turn by means of a 11 mm
wrench;
- insert the protection;
- make the coaxial cable pass through the previ-
ously bored 12 mm hole on the vehicle roof.
Fig. 12
Fig. 13
NOTE: For the connection of the antenna coax-
ial cable, it is not necessary to remove the
dome!
Central hole of
female connector
Central cable
conductor
50
9. Insulate with appropriate sealants the holes
drilled in order to prevent the passage of water.
S
WARNING
For a correct assembly, respect the installation
direction indicated in Fig. 8.
A different installation from the recommended one
could cause an incorrect operation of the antenna
due to the risk of water penetration into the
radome.
Operations to be carried out inside the vehicle.
1. Determine the correct position for the control
unit:
- it must be positioned near the satellite
receiver, as the provided coaxial cable is
1.5 m long;
- it must be reached by the power supply
cables coming directly from the battery;
- it must be reached by the coaxial cable com-
ing from the antenna (5 m long);
2. Open the control unit by loosening the screws
with an appropriate screwdriver.
Fig. 14
S
WARNING
Should it be necessary to shorten the cable, please
refer to the instructions given in Fig. 15.
www.glomexmobile.com