Glomex DISCOVERY S460S Manual De Instrucciones página 54

DISCOVERY S460S
EXPLORER S460M
To the
receiver
Red
Black
Fig. 17
4b. Only for Explorer S460M (Fig. 17)
Connect the power supply cable of the control
unit to the connector of the power supply unit
V9119. Connect the power supply cable of unit
V9119 directly to the battery: connect the posi-
tive terminal of the vehicle battery to the red
cable and the negative terminal to the black
cable. The power supply line coming from the
battery must have cables with a minimum
cross section of 2.5 mm
4 m, of 4 mm for longer cables.
2
NOTE: The connection of power supply unit V9119
is necessary for a correct operation of the appli-
ance. Its presence guarantees a stabilization of the
voltage coming from the vehicle battery.
S
WARNING
Make sure you have installed power supply unit
V9119 between vehicle battery and control unit for
the correct operation of the appliance!
From the
antenna
with a length up to
2
52
S
WARNING
Do not use power supply from secondary circuits.
This could jeopardize the operation of the equip-
ment.
NOTE: The polarity inversion on the power supply
blows the fuse to prevent any damage to the
antenna (see page 66 for fuse replacement).
S
WARNING
Pay attention not to bend the coaxial cables at a
right angle; the bending angle must always be
higher than 120°.
Fig. 18
NOTE: Do not cut the connectors of the coaxial
cables (the operation would not be guaranteed any
more) and always use the original GLOMEX cables
supplied, even with inappropriate dimensions (too
long). In case a longer cable is needed, ask the
authorized retailer for a 10 m coaxial cable, pro-
vided on demand. Do not use different cables, as it
would jeopardize the operation of the equipment.
5. Close the control unit by tightening the screws
in the rear cover.
www.glomexmobile.com
NO
NO