Hilti TE 70-AVR Manual De Instrucciones página 14

Recommended minimum conductor cross-section and maximum
power-cord length for 120V supply voltage
Cord
Conductor cross-section
Conductor cross-section
Cord length
Cord length
5 Operation
5.1 Fitting the side handle
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely.
Check that the clamping band is engaged in the groove provided on the
tool.
▶ Fit the side handle.
5.2 Fitting / removing the accessory tool
The use of unsuitable grease may cause damage to the tool. Use only
genuine Hilti grease.
Always check the accessory tool for damage and uneven wear before
each use; replace if necessary.
▶ Fit or remove the accessory tool, as applicable.
5.3 Drilling without hammer action
Drilling without hammer action is possible when accessory tools with a
special connection end are used. Tools of this kind are available from
the Hilti tools range.
When the keyless quick-release chuck is fitted, smooth-shank drill bits
for wood or steel, for example, can be used to drill without hammer
action.
▶ Set the function selector switch to the "Hammer drilling" position
5.4 Mixing 4
Use the mixing paddle only with the quick-release chuck.
10 English
Printed: 30.08.2019 | Doc-Nr: PUB / 5150793 / 000 / 02
AWG 16 AWG 14
1,31 2,08
mm² mm²
2,58 4,11
kcmil kcmil
25 m 30 m
75 ft 100 ft
2
3
4
2063039
AWG 12 AWG 10
3,31 5,26
mm² mm²
6,53 10,4
kcmil kcmil
50 m 100 m
150 ft 250 ft
.
*2063039*