Infrared Remote Control - Muskoka 23-800-001 Guía De Uso Y Cuidado

Hogar eléctrico

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

Installation (Continued)

Enable Heater/Calefacción habilitada/

Figure 3

Chauffage activé

Disable Heater/Calefacción deshabilitada/

Chauffage désactivé

Operating Instructions

The fireplace control functions can be accessed in two (2) ways:

• Using the touchpad control panel, located in the upper right-hand corner of the fireplace behind the sliding

control panel cover.

• Using the multifunction remote control unit.

The fireplace features conveniently separate controls for flame effect and for heater control. This allows you to

operate the unit in two (2) different modes:

• As a full-featured fireplace - both flame effect and heater are on.This mode allows you to enjoy the look of

the fire along with the heat output of a heater.

• As a visual effect - only the flame effect is on, the heater is off. We recommend this mode for warm weather

application, when you want the ambiance of a fire, without any heat output.

1. Main Power Button:

This button supplies power to all the functions of the fireplace. The Main Power button must be in the ON posi-

tion, either from the remote or on the touch pad for the functions to work.

2. Heater Control Button:

This button controls the heater ON/OFF and 11 temperature modes from 68°F (20°C) to 88°F (31°C). When the

heater is first turned on, it will come on at the lowest room temperature setting 68°F (20°C). Each time the

Heater Control button is pressed, the temperature set point increases 2°F (1°C), allowing you to adjust the

ambient temperature, up to 88°F (31°C). The fireplace will remember the last heat setting, and in later use, the

heater will start at that setting, unless power to the unit has been interrupted.

3. Flame Control button:

This button controls the brightness of the flame effect with settings at High, Medium and Low. When the fire-

place is first turned on, the flame will come on at the highest setting. The fireplace will remember the last flame

setting used and in later use the flame brightness will start at that setting, unless power to the unit has been

interrupted. Each time the Flame button is pressed, the flame brightness decreases. The only way to turn off the

flame effect completely is to turn off the Main Power button.

4. Timer Button:

This button controls the timer ON/OFF and 10-time setting from 30 minutes to 9 hours. When the Timer is first

turned on, it will come on at the shortest time setting (30 minutes). Each time the Timer button is pressed, the

time increases 1 hour, up to the longest setting (9 hours). Once the set time expires, all fireplace functions will be

automatically turned off.

Figure 4