Cleaning The Mesh Filter; Product Storage & Use - brondell SE400 Serie Manual Del Usuario

CLEANING THE MESH FILTER

Cleaning intervals will differ depending on use and water
quality. It is recommended to check the filter at least once a
year.
1. Turn off the water supply and hold the toilet's flush lever
down until all of the water has drained from the tank.
2. Unplug the Swash, remove the bidet from the toilet, and
disconnect the bidet hose. You may want to use a bucket
to catch any dripping water from the bidet hose.
3. Remove the Mesh Filter from the water inlet with a pair of
tweezers or needle-nosed pliers.
4. Clean the filter with a toothbrush while running under tap
water to effectively remove any foreign substances or
build-up.
5. Replace the Mesh Filter and carefully check that it is
installed correctly. If improperly installed, it could result in
the product leaking water.
6. Reconnect the bidet hose and place the seat back on the
toilet. Plug the cord back in, and turn the water supply
back on.
PRODUCT STORAGE & USE
Short Term Non-Use
If the product will not be used for more than a few weeks, you can simply unplug it. You may also
consider shutting the water supply off at the wall for extra precaution.
Long Term Non-Use
If the product will not be used for an extended time (longer
than four months), you should unplug the unit, shut the
water supply off at the wall, remove the Swash from the
toilet by forcefully pulling the Swash away from the tank off
of the mounting plate. Remove the bidet hose drain the
Hot Water Heater. To drain the Hot Water Heater, remove
the drain plug and the back of the bidet seat by turning it
counterclockwise by 90 degrees towards "OPEN" and then
pulling it out so that any residual water drains out.
Step 3
21