Special Mode Operations - brondell SE400 Serie Manual Del Usuario

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

OPERATING THE SWASH (cont.)

SPECIAL MODE OPERATIONS

NOTE:
• Do not sit on the seat when in Special Mode Operations. The process will not work while
the seat is occupied.
Seat Sensor Override
The Seat Sensor is activated at the factory by default. Completing the following steps will bypass
the body sensor located in the seat and allows the wash functions and dry functions to operate
without the sensor being engaged. Use caution in this mode.
1. Unplug the Swash bidet seat.
2. Press the two Water Pressure/Dry Temp buttons (+ and –) and plug the seat in while holding
the two buttons down.
3. Keep holding the two Water Pressure/Dry Temp buttons (+ and –) down for five seconds.
A beep will sound, indicating that the Seat Sensor has been overridden. To test that the
procedure worked, press the Dry button. If the Warm Air Dryer comes on without anyone
sitting on the seat, you have successfully overridden the Seat Sensor.
4. You can resume using the seat as normal.
5. To reactivate the Seat Sensor, repeat Steps 1-3.
Activating/Deactivating Silent Mode
By default, the Swash will beep to confirm commands from the control panel. Follow the steps
below to silence the beeping sounds.
1. Press and hold down the Rear Wash/Move button and the "–" Water Pressure/Dry Temp button
at the same time for four seconds.
2. A beep will sound, indicating that the Silent Mode has been activated.
3. To deactivate Silent Mode, repeat Steps 1-2.
18
Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Se400-ewSe400-rw

Tabla de contenido