Assembly; Troubleshooting - Astralpool Waterlift Manual De Instrucciones

Maintenance
Fig. 42: Front view of the step with the three cover screws.
2. Remove the front part of the step cover.
3. Disassemble the step plastic ramp, removing the 4 screws with a 13 mm open-ended wrench.
4. Separate the ramp from the step metal base, as shown below:
5. Remove the remaining 9 screws with the 13 mm open-ended wrench and remove the front metal
plate from the step.
6. At this point the polyamide bearings in the left handrail are visible.
7. Remove the polyamide bearings from the front (left side of the step) and remove the black runners
(right side of the step), for replacement.

9.7.2 Assembly

To reassemble the unit:
Carry out the points explained in section 9.7.1 in reverse order and finally tighten the screws evenly
(Recommended tightening torque: 6 Nm).

9.8 Troubleshooting

CAUTION
Only qualified personnel can carry out maintenance procedures.
For any maintenance activity or after-sales service, contact the nearest distributor or
authorised technical service
34/196
Fig. 43: Step plastic ramp.
Fig. 44: Step front metal plate.
Fig. 45: Side and front view of the bearing.
.
Instructions Manual Waterlift rev.0.7 -06/09