Call Waiting; Call Reject; Multipoint; Multipoint Connect - LG HBM-800 Manual De Uso

How to use Headset

Call waiting*

- Answer a second call without hanging up the first call by pressing the
CALL button for 1 second. Press the CALL button for 1 second to return
to the original call.
- Briefly press the CALL button to terminate the active call or both calls
at once. (subject to handset's support)

Call Reject*

- Activate Call Reject by pressing the CALL button for 1 second when
the headset rings.
* It is possible to use these functions only when your handset supports
them. For further information about using these features, please
consult your handset's user manual.

Multipoint

The LG HBM-800 is capable of having two handsets connected to the
Headset at the same time. This will give you the freedom of having only
one Headset to operate both of your handsets.

Multipoint Connect

- Pair the Headset with one of your Bluetooth-enabled handsets.
(Refer to the pairing instructions on pages 5-6).
- Turn off the Headset.
- With the power off, press and hold the PWR button on the HBM-800
for 5 seconds to enter Manual Pairing mode.
- Now, pair and connect the Headset with your other Bluetooth-enabled
handset. (This will be your Primary handset).
- Once this handset is paired and connected, go back and connect the
first paired handset to Headset. (This process should be done through
your handset's Bluetooth menu)
* Note: When the HBM-800 is connected to two handsets at the same
time (Multipoint), the Headset calling functions will work with
the most recently used handset.

Calling Functions

- Voice Dial and Last Number Redial features work with the Primary
handset. (most recently used handset).
- The first connected device is set as primary handset and the next
connected device is set as secondary handset.
- The device which made the last outgoing call will always be set as
the primary handset.
8
- To answer an incoming call on your secondary handset, while on a call
on your primary handset, hang-up the active-call (briefly press the CALL
button) and then answer the incoming-call (briefly press the CALL button
again).

Sun Visor Clip

Charging

- Remove the cover on the charging port and connect the charger.
- The LED indicator will show a solid red light.
- It takes 2 hours to fully charge the Cradle.
- When charging is complete, the LED indicator will turn off.

Low battery

- A low battery tone will play once every 30 seconds.
- If the battery is not charged, the Cradle will turn off.

Power on

- Press and Hold the MFB for 3 seconds.
�The power will turn on and a booting tone will play.

Power off

- Press and hold the MFB for 3 seconds.

Volume control

- Press the VOLUME UP or VOLUME DOWN button to adjust the speaker
volume.
- There are eight levels of speaker volume.
- You will hear an alert tone when the volume is at the maximum or
minimum level.
How to use Headset

How to use Cradle

9