Prior To Commissioning - Taski ergodisc HD Manual De Instrucciones

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 55

Prior to commissioning

Brush installation
Before inserting, please check:
• that the brush does not fall below the red marking (bristles)
or 1cm of bristle length.
• the pad for wear and cleanliness before use.
Attention:
Do not use brushes which have reached
their wear limit. The wear limit is indicated
by the length of the red bristle. Do not use
worn or contaminated pads. Use original
TASKI brushes only. Failure to observe
these instructions may result in inade-
quate cleaning results or even floor dam-
age.
• Put the tool on the floor in line with
the machine.
• Stand behind the machine.
• Operate the adjusting lever at the
machine handle and lower the guide
bar slowly until your arms are
stretched out (working position).
• Release the adjusting lever to lock
the guide bar.
• Tilt the machine backwards, roll it to
the tool and lower it with the housing
over the tool.
• Tilt the machine up.
• Move the machine handle to the right
and left until the tool engages.
The machine is now ready for use.
48
Application technique
Machine
Wet & base cleaning
Spray cleaning
Shampoo wet (not on carpet)
Shampoo dry (not on carpet)
Polish
Grinding
Crystallization
Dosing:
Attention:
Wear gloves, goggles and appropriate
(protective) working clothes when han-
dling chemical products!
Notice:
Use chemical products recommended by
Diversey only and always observe the
product information.
Caution:
Using unsuitable products (e.g. products
containing chlorine, acids or solvents) may
cause harm to health and severe damage
to the machine.
Notice:
The correct dose is specified on the prod-
uct packaging and in the "TASKI Product
information sheet".
HD
yes
no
yes
yes
no
yes
yes
loading