Tabla de contenido
Idiomas disponibles
Idiomas disponibles
10.8 FROST PROTECTION FUNCTION
A minimum temperature can be set below which the stove will switch on (outside of the set time bands, and only
if the timer is active). To set the "frost protection" temperature:
a) Use the arrow buttons
b) Use the
button to select the password "7" and then press
c) Select submenu
d)
e) Press
11
ALARM MANAGEMENT
If a malfunction occurs, the following procedure is activated:
1) audible alarm (beep);
2) one of the following system LEDs come on:
3) if the problem concerns an error, the stove will switch off.
Pressing and holding the "cancel" button
ERROR/
WARNING CODE
E001
Faulty control panel
E002
Remote control signal communication error
E004
Communication error
E101
Failed ignition error
E105
Pellet probe malfunction
E108
*
Safety error
E109
Pressure error or thermal safety
E110
Temperature probe malfunction
E111
Flue gas temperature probe malfunction
A001
Low pellet level ico
A002
Scheduled maintenance warning ico s as i
A007
Pressure sensor malfunction ico
----
Clean stove
----
Failed ignition error
* Only for the models equipped with safety microswitches on the door or on the hopper lid.
After having checked the type of message, the alarm can be reset by pressing the on/
off button
for a few moments.
If the error code is "
located on the rear of the stove (Fig. 11.1) t is s o ld e carried o t
tec
icia . Then the stove can be started again.
cod. 00 477 2290 - 04/2015 - Palazzetti - PN - Italy
USE AND MAINTENANCE
to go to the setup menu
[9]
shows the error code on the display:
DESCRIPTION
as i
E109
", before resetting the alarm, manually reset the thermostat
and then press
;
OFF
3...20
buttons (
;
°C);
;
POSSIBLE CAUSES
Control panel fault
Control panel fault
Connection cable between board and control panel
interrupted or detached.
the error
No pellets
Pellet quality
Faulty ignition system
Burn pot dirty
Problems with the heating system
Problems with the pump
Pellet probe disconnected or faulty
Door or hopper lid open
Flue gas exhaust system dirty
Seal gaskets worn
Problems with overheating in the pellet hopper
Faulty air temperature probe
Pellets running out
The stove periodically requires maintenance to be
as i
Pressure sensor or board fault.
system dirty.
Pressure measuring tubes detached or blocked.
Combustion air intake blocked.
No pellets; Faulty ignition heater; Worn gaskets;
Incorrect burn pot position
a a t ori ed
;
LED
51
Tabla de contenido
