Special Functions Via The Standby Mode; Fastscan Function (Us Only) - EPAK Basic Serie Manual

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the  key.
6.3

Special functions via the Standby mode

The following information can be obtained via the Standby mode: software version of
antenna unit and control unit, serial number and operating hours counter.
Please proceed as follows:
1. Turn on the control unit. The display shows Init, meaning initialization is started. Wait
for the initialization to be completed, and then press the  key to enter the Standby
mode.
2. To obtain the special functions, press and hold the  key while switching between the
following functions with the  key:
" serial number.
" operating hours counter.
" software version of the antenna unit: VA X-XX
" software version of the control unit: VC X-XX
3. After releasing the  key, the display returns to Standby.
6.4

Fastscan function (US only)

The tracking system works faster with the Fastscan function. However, if the antenna is
locked to a satellite and the TV does not show a picture, the Fastscan function can be
deactivated by following these steps:
1. Press  repeatedly until the display shows Setup (flashing), then press . Enter
password, see chapter 3.4. If the password is correct you are in the Setup menu with
Tracking on the display.
2. Press  repeatedly until FastScan appears. Press  to confirm.
3. Press 
4. The display now returns to FastScan. Press  until quit appears and confirm
with . The display shows Setup (flashing).
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu by pressing the
t o switch from On to Off, and confirm with .
English Page 20 / 34
key.
Tabla de contenido
loading

Este manual también es adecuado para:

River serieTv 44Tv 59Tv 43Tv 58

Tabla de contenido