Stopping The Tracking Function In Harbours - EPAK Basic Serie Manual

chapter 4.1).
Should the antenna lose the signal from the satellite (due to a passing boat, buildings on
shore, bridges, or superstructures on own boat), the display will interchange between Sat
X (stored position of current satellite) and no Sig for the duration of the missing
satellite reception.
The tracking mode will automatically restart if the satellite signal could not be found within
30 seconds. The display interchanges between scanning and Sat X. In case
superstructures obstruct the view to the satellite, turn the vessel or the satellite cannot be
found!
!! To select a stored satellite, refer to chapter 5.4.
4.1

Stopping the Tracking function in harbours

If the boat is in a harbour, the tracking function can be deactivated to stop the tracking
(noise-reduction). Proceed as follows:
1. Press  repeatedly until the display flashes. You are in the main menu.
2. To go to the Setup menu, press  repeatedly until the display shows Setup
(flashing), then press . Enter password, see chapter 3.4. If the password is correct you
are in the Setup menu with Tracking on the display.
3. Press  to select, and press 
must be in OFF position to be deactivated. Confirm with .
4. The display returns to Tracking. Press repeatedly until the display shows quit.
Confirm with . The display returns to: Setup.
You are now back in the main menu and can switch to other satellites or make adjustments
in the Setup menu.
!! When the tracking function is deactivated, the antenna does not track the satellite, so it is
possible that the TV picture sometimes can deteriorate or drop out. A realignment with
the satellite is always possible: Press  repeatedly until the display shows a flashing
Sat X ( whereas X is the respective number of the selected satellite). Confirm with
.

t o switch between ON and OFF. The tracking function
English Page 14 / 34