EPAK Basic Serie Manual página 51

5. You can see Compass for two seconds. ON is given as standard. With  you can
choose OFF and switch off the compass. Please confirm your choice by pressing .
(Also see chapter 6.1)
6. The display interchanges between New Sat and Search?.
7. Confirm with , or cancel with .
8. In case you canceled the process, the display will briefly show cancel and then
return to the Setup menu showing New Sat (see point 2!). If you confirmed, the
search mode is activated and the display shows scanning (flashing). The search
mode can be interrupted at any time by pressing , which brings you back to the main
menu. The display shows Setup (flashing).
9. If the tracking system has scanned the whole area without locating a satellite, the display
shows scanning interchanging with complete. Confirm with . You are back
in the main menu with Setup flashing. Before restarting the search mode (see point
1), check if there is a clear view to the satellite, if the program selected on the receiver is
o.k. (possibly change to another program) and if the respective satellite can be received
in this area! If no satellite is found, repeat the search in another band (see point 3).
!! Before you restart the search-mode, make sure that no superstructures obstruct the view
to the satellite!
10. The search-mode stops after a satellite is found. The display shows Sat ok?
(flashing). Check the quality of the TV picture! In case there is no picture or the wrong
TV program, proceed with the search-mode by pressing  repeatedly until the correct
TV program is found. Press  to confirm.
11. The display shows Save as? just for a brief moment.
12. A list of the different storage positions is shown. Use the
Sat 1 and Sat 4, confirm with .
Note! If you want to use the Auto-Sat function (see chapter 5.4.1), please consider that only
free storage positions are shown. Every receiver supporting the DiSEqC™ function
allocates the satellite positions to one of the DiSEqC™ positions 1 – 4. Therefore, make
sure that all satellites in the DiSEqC™ menu of the receiver and of the antenna unit are
stored under the same number! This allows the use of the Auto Sat function (see chapter
5.4.2).
!! Example: Satellite Astra is stored under DiSEqC ™ position 2 in the receiver, meaning
that this satellite has to be stored in the antenna unit under Sat 2! Receivers which do not
support the DiSEqC ™ function will allow any order of numbers. Press .
13. The display interchanges between a flashing Sat X and save?, whereas X is the
previously chosen storage position. Confirm with
If you want to cancel the function, press
will briefly show cancel and then return to Sat ok?. You may now continue the
search, or you can store the satellite just received at another storage position. (see point
4).
14. If you chose to confirm in point 13, the display shows saving..  (flashing) for appr.
1 minute. The data of the satellite is now automatically memorized and stored. The
display briefly shows: checking.
!! While the data is being stored, the ship must not move, a permanent clear view to the
satellite must be guaranteed, and the antenna unit must not be turned off!
15. When the data is memorized, the display shows complete for a brief moment and

, which interrupts the storage. The display
English Page 16 / 34

key to choose between

. (continue with point 14)