Installation Instruction - LG PQRCHCA0Q Manual De Instrucciones

INSTALLATION INSTRUCTION

1
Please fix tightly using provided screw
after placing remote controller setup board
on the place where you like to setup.
- Please set it up not to bend because poor
setup could take place if setup board
bends.
Please set up remote controller board fit
to the reclamation box if there is a recla-
mation box.
2
Can set up Wired remote controller cable
into three directions.
- Setup direction: the surface of wall recla-
mation, upper, right
- If setting up remote controller cable into
upper and right side, please set up after
removing remote controller cable guide
groove.
❈ Remove guide groove with long nose.
① Reclamation to the surface of the wall
② Upper part guide groove
③ Right part guide groove
<Wire guide grooves>
3
Please connect indoor unit and remote
controller using connection cable.
INSTALLATION INSTRUCTION
Please check if connector
is normally connected.
FAN
SPEED
TEMP
ROOM
TEMP
4
Please use extension cable if the distance
between wired remote controller and in-
door unit is more than 10m.
5
Please fix remote controller upper part into
the setup board attached to the surface of
the wall, as the picture below, and then,
connecta with setup board by pressing
lower part.
- Please connect not to make a gap at the
remote controller and setup board's
upper and lower, right and left part.
<Connecting order>
Wall
Side
When separating remote controller from
setup board, as the picture below, after in-
serting into the lower separating hole
using screw driver and then, spinning
clockwise, remote controller is separated.
- There are two separating holes. Please
individually separate one at a time.
- Please be careful not to damage the in-
side components when separating.
<Separating order>
Wall
Side
7
Indoor
Unit
side
Connecting
cable
Wall
Side
Wall
Side