Installation - Würth ACCTIVA EXPERT Manual De Instrucciones

Installation

If installing the charger on a firm base, use drilling template enclosed in the packaging.
Remove the edge guard temporarily.
The space requirement measurements in mm (inches) illustrated below are given to
ensure that there is easy access to the plug connections:
Space requirements with edge protection
NOTE! Protection IP44 is only guaranteed for the upright position.
If the charger is installed in a switch cabinet (or similar separate area), then forced-air ventilation must be provided to ensure adequate heat dissipation.
There should be a gap of 10 cm (3.94 in.) all around the charger.
168
(6.61)
270 (10.63)
*Space for fitting/removal
6
100 (3.94)
15,5 (.61)