Der Koch Eltz Manual De Instalación Y Funcionamiento página 46

Plantillas de Vitrocerámica
• This appliance must be wired into a 30 A double pole switched fused
spur outlet, having 3 mm contact separation and placed in an easily
accessible position adjacent to the appliance. It should not be located
above the appliance and no more than 1.25m away from it.
• The cable can be looped if necessary, but make sure that is not kinked
or trapped when the hob is in position. Care must be taken to avoid the
cable being in contact with hot parts of the appliance.
Replacing the mains supply cable
If the mains supply cable is damaged, then it must be replaced by an
appropriate replacement.
The mains supply cable should be replaced in accordance with the following
instructions:
• Switch the appliance off at the control switch.
• Open the terminal block on the underside of the hob.
• Unscrew the terminal screws fixing the cable.
• Replace the cable with one of the same length and in accordance with
the specification given before.
• The "green-yellow" earth wire must be connected to the terminal
marked . It must be about 10 mm longer than the live and neutral
wires.
• The "blue" neutral wire must be connected to the terminal marked with
letter (N) - the live wire must be connected to the terminal marked with
letter (L).
www.derkochline.com
Ceramic Hob
45