Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Plantillas de Vitrocerámica
E-VIII.1 ASSEMBLY OF CERAMIC HOB ELTZ
• Make an opening with the dimensions given in the diagram for the hob
to be mounted on the worktop．
• Check seal for perfect fit and overall cover. Lower the electric hob
into place and align correctly. Do not leave a gap in the sealing agent
or overlap the thickness.
• Note: do not use any Silicone based sealant, as this can damage the
worktop surface if repairs are required.
IMPORTANT: You must observe the ventilation requirements shown in the
drawing opposite There are ventilation holes around the outside of the
hob. YOU MUST ensure that these holes are not blocked by the work
top, when you put the hob into position.
Using a standard screwdriver, tighten the tension
clamps evenly starting at the centre and moving
diagonal, until the built-in rim is tight on the
worktop.
www.derkochline.com
Ceramic Hob
40
Tabla de contenido
