Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Plantillas de Vitrocerámica
Fitting guidelines
2
1
Remember that the connection wire should match the connection type and the
power rating of the ceramic hob.
The connection cable must be secured in a strain-relief clamp.
E-VIII.2 Assembly of ceramic hob Olpe:
• Make an opening with the dimensions given in the diagram for the hob to be
mounted on the worktop．
• Check seal for perfect fit and overall cover. Lower the electric hob into place and
align correctly.
• Using a standard screwdriver, tighten the tension clamps evenly starting at the
centre and moving diagonal, until the built-in rim is tight on the worktop.
Cut a hole in the worktop that corresponds with the drawing shown above.
IMPORTANT: You must observe the ventilation requirements shown in the
drawing opposite.
The ceramic hob is manufactured to work with one-phase
alternating current.The voltage rating of the ceramic hob
heating elements is 220-240V. Adapting the ceramic hob
to operate with two-phase current is possible by
appropriate bridging in the connection box according to
the connection diagram below. The connection diagram
is also found on the cover of the connection box.
www.derkochline.com
Ceramic Hob
42
Tabla de contenido
