Replacing The Light Fixture; Section 5. Wiring Options For Controlling Jandy; White Led Lights - Jandy Pro Serie Manual De Instalación Y Operación

5. The wet niche must be properly electrically
bonded and grounded via the No. 8 AWG ground
connector located at the rear of the niche. See
Figure 1.
To be certain that the pool's electrical system meets
all applicable requirements, the electrician should also
consult the local building department.
4.2

Replacing the Light Fixture

NOTE
Perform these steps only after the electrical system
requirements are met.
WARNING
Failure to bring the pool's electrical system up to code
requirements before installing the underwater light
will create an electrical hazard which could result in
death or serious injury to pool or spa users, installers,
or others due to electrical shock, and may also cause
damage to property.
NOTE
The light fixture may be replaced without removing
water from the pool.
1. Turn off the main electrical switch or circuit
breaker, as well as the switch, which operates the
underwater light.
2. Unscrew the special pilot screw at top of the
face ring and remove the light assembly from the
niche, and place the assembly on the deck.
WARNING
Be sure to keep the special pilot screw provided
with this underwater light. This screw mounts and
electrically grounds the housing securely to the
mounting ring and wet niche. Failure to use the screw
provided could create an electrical hazard, which could
result in death or serious injury to pool or spa users,
installers or others due to electrical shock.
3. Remove Junction Box cover, disconnect the light
fixture wires and strain relief, and then pull the
cord out of the conduit from the niche.
4. Feed the new light fixture cord through the
conduit from the niche to the Junction Box.
NOTE
Depending on the length of the conduit, special tools
may be required to pull the cord through the conduit.
5. Leave at least four (4) feet of cord to coil around
the light fixture or coiled into the base of the light
niche, see Figure 1. This allows the light to be
serviced after the pool is filled with water.
Jandy Pro Series, White LED Lights
®
|
Installation Manual
6. Cut the cord at the Junction Box, leaving at least
six (6) inches of cord to make connections.
7. Strip six (6) inches of the outer cord jacket from
the cord to expose the three insulated wires. Be
careful not to damage the insulation on the three
(3) inner wires.
8. Install the strain relief over the cord jacket and
connect all three wires to the corresponding
circuit wires in the junction box. Install the
junction box cover.
9. Reinstall the light assembly into the niche and
tighten the special pilot screw.
WARNING
Use only the special pilot screw provided with this
underwater light. This screw mounts and electrically
grounds the housing securely to the mounting ring
and wet niche. Failure to use the screw provided could
create an electrical hazard, which could result in death
or serious injury to pool or spa users, installers or
others due to electrical shock.
10. Fill the pool until the underwater light is
completely submerged in water before operating
the light for more than 10 seconds. Turn on main
switch or circuit breaker, as well as the switch,
which operates the underwater light, to check for
proper operation. Refer to Section 6, Operating
Instructions.
WARNING
Never operate this underwater light for more than
10 seconds unless it is totally submerged in water.
Without total submersion, the light assembly will get
extremely hot, which may result in serious burns or in
breakage of the bulb or lens. This may result in serious
injury to pool or spa users, installers, or bystanders or
in damage to property.
Section 5. Wiring Options for
Controlling Jandy
Pro Series White LED
Lights
NOTE
The Jandy Pro Series White LED Lights will not
operate properly with light dimmers. Do not wire the
Jandy Pro Series Lights to any dimming circuitry.
Page 7
ENGLISH