Section 7. Operating The Laminar Jet With Led Light; To Operate The Light And Change Colors - Jandy JLLED4C Serie Manual De Instalación Y Operación

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Page 12
ENGLISH
Figure 10. Laminar Jet Light and Flow Adjustment
4.
Use the flow adjustment valve to make final
adjustments to the overall water height of the jets.
NOTE: Laminar jets are sensitive to wind, earth
movement and equipment vibration. Secure
the laminar jet and deck canister to minimize
vibration. Periodic stream distortion caused
by pump vibrations and motor electrical
fluctuations is normal and not indicative of a
nozzle defect. Also, occasionally a nozzle will
"burp" due to pumped air collecting in the nozzle
body. This is normal and will occur until all air
is purged from the piping system. Trapped air
can also cause slight distortion in water action.
It is imperative that all air is removed to ensure
proper water feature operation.
5.
To adjust the angle of the jet move the laminar
jet up or down to increase or decrease the angle
by hand or using a screwdriver in the angle
adjustment slot.
NOTE: The angle can be adjusted approximately 10°.
6.
The laminar jet is installed on two (2) pivots.
Loosen the locking screws to adjust the jet angle.
Once you are satisfied with the angle and location
of the jet, tighten the locking screws.
7.
Secure the deck canister lid to the deck canister
collar, using two (2) #10 by 1½ inch (38 mm),
Phillips flat head stainless steel screws.
Jandy
Laminar Jet | Installation and Operation Manual
®
Lid
1" Stake Up Feature
Screwdriver
Slot
Light Intensity
Adjustment Screw
Angle Adjustment Slot
Flow Adjustment Valve
Laminar Jet
Pivot
Figure 11. Locking Screw Location
NOTE: It is recommended to drill 1/8" (3 mm) pilot
holes in the lid. Then the screws can be
threaded into the holes. This will complete the
installation and secure the jet from movement.
Section 7. Operating the Laminar Jet
with LED Light
7.1
To Operate the Light and
Change Colors
Turn the light ON. The first time the light is turned on,
the color sequence begins with the Alpine White. To
change the color, turn the light OFF and then ON within
three (3) seconds. Continue turning OFF and ON until
the desired light color mode is reached.
Locking Screw
Tabla de contenido
loading

Este manual también es adecuado para:

Jlfbr serie

Tabla de contenido