BLUE EMBER GRILLS FGQ65079 Manual Del Usario página 43

FOR PROPANE MODELS PLEASE FOLLOW FIG 18 & 19
PROPERLY POSITIONED GAS TANK AND HOSE ASSEMBLY
ENSURE THE PROPANE TANK AND GAS HOSE ARE PROPERLY
POSITIONED FACING TOWARD THE FRONT OF THE CART.
Before attaching hose/regulator to tank, be sure cylinder valve and
appliance valves are OFF.
The Q.C.C.1 cylinder valve has an internal back check module which
will not allow gas to flow until a connection has been made. The
valve is turned off by rotating the handwheel (Fig. 3, Use and Care)
Clockwise (left to right) until it stops. When attaching regulator to
tank, make sure that the small probe (Fig. 13) in the nipple is
centered in the mating Q.C.C.1 cylinder valve, turn the right hand
threaded Q.C.C.1 nut onto the valve in a clockwise motion until there
is a positive stop. DO NOT USE A WRENCH, HAND TIGHTEN
ONLY.
TANK & HOSE/REGULATOR ASSEMBLY
Lift & Pull Handle
to release
• Position tank into tank support as shown.
THIS BARBECUE IS DESIGNED
!
TO BE USED ONLY WITH A 20LB
WARNING
(9.1KG) PROPANE CYLINDER
WARNING:
Before proceeding with the following steps,
ensure you have read: • L.P. Gas Cylinder • Hose and
Regulator
Sections of the USE AND CARE INSTRUCTIONS located at
the front of this manual. The L.P. gas cylinder, if supplied
with your grill, has been shipped empty for safety reasons.
The cylinder must be purged of air, and filled, prior to use.
Follow all directions under "L.P. Gas Cylinder - Filling"
section of the Use and Care Instructions.
TANK
43
FIG.18
FIG.19
HOSE/REGULATOR
Q.C.C.I. NUT
IMPORTANT:
Ensure hose
assembly does not contact the
casting, or any other parts which
will get hot.