Installation Modes - Palazzetti ECOFIRE Serie Manual De Instrucciones

6

INSTALLATION MODES

You can install the stove in different ways:
6.1 COAXIAL PIPE
It is possible to use a coaxial pipe for smoke outlet
and air intake.
To do this, simply connect a coaxial pipe, because
the stove is already configured for this type of
installation (6.1).
The technician is responsible for chimney
dimensioning according to the situation of
the installation and the product used. It is
recommended not to exceed 7 meters equivalent
with a coaxial tube of 13/8 cm.
6.2 SINGLE WALL PIPE AND FREE AIR
INTAKE
In this case the combustion air will be taken from
the environment.
Connect the flue outlet pipe (e) after installing the
aesthetic ring support (c) and the ring itself (d) as
shown in figure (6.2). Make sure you have made
an adequate air intake in the environment, as
specified in the previous
6.3 SINGLE WALL PIPE AND OUTSIDE
AIR CONNECTION
In this case the combustion air will be taken directly
from outside by the rear of the stove.
Disassemble the back of the stove (a) and
disconnect the combustion air hose only in the
upper side (b); connect the flue pipe (e) after
mounting the aesthetic ring holder (c) and the
ring (d) as shown in figure (6.3); Remove the
pretrimmed on the back (f), and pass through hose
to connect it to an external air intake. Replace the
back pane
INSTALLATION
paragraphs.
00 4777020 -09/2018 - PALAZZETTI - PN - Italy
E
fig. 6.1
E
D
fig. 6.2
C
fig. 6.3
C
B
A
E
D
27