Led Indicators - Axis P7214 Installation Guide

Page 10
RS485/RS422 connector - Two 2-pin terminal blocks for RS485/RS422 serial interface used to
control auxiliary equipment, e.g. PTZ devices.
The RS485/RS422 serial port can be configured to support:
• Two-wire RS485 half duplex
• Four-wire RS485 full duplex
• Two-wire RS422 simplex
• Four-wire RS422 full duplex point to point communication
Function
RS485/RS422 RX/TX A
RS485/RS422 RX/TX B
RS485/RS422 TX A
RS485/RS422 TX B
microSD memory card slot - The microSD memory card can be used for local recording with
removable storage.
BNC connector - Connect a 75 ohm coaxial video cable (max. length 800 feet (250 meters)).
Note:
For each video input 75 Ohm video termination can be enabled/disabled via the product's web page at
Video & Audio > Video Input > Video termination. These terminations are enabled on factory default.
In cases where the product is to be connected in parallel with other equipment, for optimum video
quality, it is recommended that termination be enabled for only the last device in the video signal
chain.

LED indicators

LED Color
Network Green
Amber
Unlit
Status Green
Amber
Red
Power Green
Amber
Pin Notes
1 (RX) For full duplex RS485/RS422
(RX/TX) For half duplex RS485
2
3 (TX) For full duplex RS485/RS422
4
Indication
Steady for connection to a 100 Mbit/s network. Flashes for network activity.
Steady for connection to 10 Mbit/s network. Flashes for network activity.
No network connection.
Steady green for normal operation.
Steady during startup, during reset to factory default or when restoring settings.
Slow flash for failed upgrade.
Normal operation.
Flashes green/amber during firmware upgrade.
AXIS P7214 Installation Guide
RS-485/422 RS-485/422
RX/TX RX/TX
1 2
T X
3 4