Panasonic AW-RP50E Manual Del Usuario página 28

Connections
 When setting the IP addresses for 
the first time
The IP addresses are set while the remote cameras,
switcher and unit are at their factory settings.
Note
Before setting the IP addresses, check that
"NoAsign" is shown as the remote camera's
connection setting.
Connection settings:
On the [SYSTEM] menu, select [CAMERA CTL], and
then display items [CAM1] to [CAM100].
1
Connect the remote cameras, switcher
and unit to the network within the same
subnet.
192.168.000.010
192.168.000.011
192.168.000.010
192.168.000.010
192.168.000.009
2
On the [SYSTEM] menu, select [AUTO
SET IP], and display [AUTO SETUP].
Then select "RENEW IP ADR", and press
the F2 dial.
1 . A U T O S E TU P
R E N EW IP A DR
Both the number of devices (all remote cameras
and the switcher) currently being managed by the
unit and the number of new devices detected are
displayed on the LCD panel.
C: 0 0 3 / 0 0 3 S : 1 /1
C: 0 0 3 / 0 0 3
Number of devices currently
managed by the unit + Number of
new devices detected
Number of new devices detected
192.168.000.010
192.168.000.012
192.168.000.008
192.168.000.008
Y ES
C: Remote camera, S: Switcher
 Memo 
  If the number of new devices detected exceeds
the number of devices that can be registered
(100 remote cameras and 1 switcher), [C/S OVER!]
will be displayed at the bottom of the LCD panel.
Automatic IP address setting can be performed
even in this state, but IP addresses will be set only
for the number of devices that can be registered.
C : 0 20 / 1 0 0 S : 1/ 1
C / S O V E R !
  When a multiple number of remote cameras have
been started up at the same time, for instance, it
may not be possible for all of these cameras to be
detected by the unit.
In this case, select "RETRY", and then press the F2
dial to retry the operation.
The number of units to be added can be updated.
  The number displayed for "Number of new devices
detected" may be lower than the actual number
of devices to be set, due to a cause such as the
remote cameras or switches not being powered on.
In this case, eliminate the cause of the problem,
select "RETRY", and then press the F2 dial to retry
the operation.
The number of units to be added can be updated.
C : 0 20 / 0 2 0 S : 1/ 1
27 (E)
YE S
R E TR Y