Tabla de contenido
Idiomas disponibles
Idiomas disponibles
HOW TO REMOVE THE CHUTE
1. Remove the fasteners that secure
the chute to the top cover.
2. Remove the chute.
Chute
Top
Cover
Figure 26
HOW TO ADJUST THE BRAKE PAD
IMPORTANT"
An adjustment
is only
necessary
if the brake
pad has become
loose or has been
removed.
To adjust,
proceed
as follows:
1. Remove the top cover. See "How To
Remove The Top Cover".
Remove
the belt cover.
See "How
To Remove
The Belt Cover".
Screw
Brake
Pad
Drive Belt
3. Tie the auger drive lever to the han-
dle. This wi!! engage the drive sys-
tem.
4. Loosen the screw and nut on the
brake pad arm (Figure 27).
5. Set the clearance between the
brake pad and the drive belt to 1/8
inch.
6. Tighten the screw and nut on the
brake pad arm.
..<.i:.'"
.
Engine
Pulley
•:::'
Belt Guide
Brake Roller
Figure 27
F-051010C
22
Tabla de contenido
