Sears CRAFTSMAN 536.881501 Manual De Propietario página 20

[.,,."_o,,_ V_I Z IB]P'_"_
HOW TO REMOVE THE TOP COVER
1. Remove the discharge chute. See
"How To Remove The Discharge
Chute".
2. Remove the fuel cap.
3. Remove the two bolts (A) and nuts
from the front of the top cover,
4. Remove the two bolts (B) and nuts
from the left and right side of the
top cover.
5. Remove the eight screws (C) on
the left and right side of the top
cover,
6. Remove the five screws (D) from
the top portion of the control panel.
7. Carefully pull the rear of the top
cover up and over the gas tank.
8. To install the top cover, reverse the
above steps.
HOW TO REMOVE THE BELT COVER
1. Remove the bolts (E) and nuts that
hold the belt cover to the auger
housing.
2. If the top cover has not been re-
moved, then remove the screws
(C) that attach the belt cover to the
top cover.
3. Remove screw (F) that holds the
belt cover to the bottom cover.
4. To remove, hold the bottom portion
of the belt cover and pull down and
out.
5. To install the belt cover, reverse the
above steps.
T_,,_H Cover / i
//
'/ i
/
/
C
BeltCover
F
Figure 22
F-0510100 20