Maintenance Instructions; Routine Maintenance - Hoshizaki Snowflake GII SUR-65BG Manual De Operación, Mantenimiento E Instalación

Sno wf lak e GII
III. MAINTENANCE INSTRUCTIONS
This section is particularly intended for the owner/user of the product. It provides important
information on the correct usage and for the maximisation of the product's life span.
Few simple steps during usage and adjustment can reduce the need for expensive repairs by service
technicians. These steps do not require special technical knowledge.
Before you begin cleaning and maintenance on the product, make absolutely sure the power supply
has been turned off and cannot be reconnected accidentally by anyone else.
Do not wash the product with high pressure water. Avoid any possibility spraying into the electrical
components.
CLEANING

It is recommended that periodically the inside of the cabinet is cleaned with disinfecting
detergents. Internal cleaning of the cabinet should be carried out by using warm and slightly
soapy water.

Only pH neutral or slightly alkaline detergents may be used to clean the interior and the
exterior of the cabinet.

Damage caused by cleaning products containing chemicals that could damage stainless steel
is not covered by the warranty.

Never use metal implements, metal scouring pads nor scouring creams or powders.

Dirt can be cleaned with a damp cloth.

Keep the ventilation grilles of the cabinet clean and clear at all times.

Shelves are removable for easy cleaning access.

Ensure that the shelf runners and shelves themselves are cleaned thoroughly.
The product is made out of stainless steel. When used in normal conditions stainless steel does not
corrode, however corrosion of stainless will occur if corrosive detergents are used.

ROUTINE MAINTENANCE

CONDENSER
It is very important that the condenser is capable of maximum heat transfer. Therefore, the surface
of the condenser must always be clean and clear. Due to the effect of the fan, dust will accumulate
on and inside the condenser fins. A vacuum cleaner with a brush attachment can be used to clean
the condenser.
Pay particular attention to avoid causing any damage to the condenser fins or the fan blades.
If there is a filter, remove the filter to clean it and then replace it. Replace the filter if it is damaged or
too dirty to clean properly.
IMPORTANT
ATTENTION
IMPORTANT
EN 12