80 L Assembly Instructions - Weston PRO-1200 Manual De Instrucciones

80 L ASSEMBLY INSTRUCTIONS

1. Make sure the Dehydrator is turned off and unplugged.
2. Remove the Racks and any other loose items from the interior and close
the Door.
3. Gently lay the Dehydrator onto its left side (when facing the Door) on a
rug or other similar article to prevent scratching. DO NOT lay the Dehydrator
onto its right side or front to avoid damaging the Door, Control Panel and/or
Circuit Breaker.
4. Insert the Foot Bolts into the holes at the bottom of the Feet until the Bolts
threads protrude out. Thread the Bolts & Feet into the Front Foot Brackets.
5. Tighten the Foot Bolts with a screwdriver.
6. While holding the Door closed, carefully stand the Dehydrator upright
onto the Feet.
160 L ASSEMBLY INSTRUCTIONS
1. Follow steps 1-3 above.
2. Screw a Caster Nut (attached to Caster for shipping) onto the threaded
stem of each Caster until it stops.
3. Screw the Swivel Casters into the Rear Bottom Corner Brackets until they
stop. HINT: Hold the Caster frame with one hand and rotate the swivel with
your other hand.
4. Screw the Swivel Casters with Breaks into the Front Foot Brackets until
they stop.
5. Tighten each Caster Nut with a 12-mm (1/2") open-end wrench. Turn the
Caster Nuts clockwise. You want to tighten them to the Dehydrator, not the
Casters. DO NOT over-tighten.
6. Inspect the gap between the Door and Front Left Foot Bracket to make
sure the stem of the Caster does not contact the bottom of the Door. If there is
contact, loosen the Caster Nut and move the Caster down. Screw the Caster
Nut onto the stem of the Caster, but do not screw it all the way down. Leave
a small gap to shorten the stem that protrudes through the Foot Bracket.
Reinstall the Caster as described above.
7. While holding the Door closed, carefully stand the Dehydrator upright onto
the Casters.
8