Dimplex CDFI-BX1500 Manual Del Propietário página 9

Installation
Figure 3
Back Panel
8. In the back left corner of the
Opti-myst Cassettes, locate and
remove the electrical cover plate
by removing the two securing
screws. (Figure 4)
9. Remove the top of the junction
box using the 2 screws. On the
left side, install the power supply
cable through a cable connector
(not included) suitable for a 7/8''
(22mm) hole. (Figure 5)
CAUTION:
non-metallic sheath cable with
ground wire (3 wires total) for the
incoming power supply on the
cassette and junction box. Use
appropriate wire to meet local
and national electrical codes for
rated power.
Flange
Use two conductor,
Plumbing
Routing
Figure 4
Electrical Cover Plate
Holes for
securing to
framing
Figure 5
Supply Cable Entrance
Wire
Routing
Cable Plate
To CDFI1000-PRO
To CDFI500-PRO
9