Weller WD 1 Manual De Instrucciones página 25

WD 1 (M) / WD 1000
7.1 Selecting Menu 1 special functions
Special functions
STANDBY
SETBACK
AUTO OFF
OFFSET
WINDOW
°C / °F
1. Press and hold down the UP and DOWN buttons simultaneously.
"– 1 –" appears in the display after 2 s.
2. Release the buttons.
Selection of the special functions of Menu 1 is activated.
The settings can now be made.
- Press the I, II buttons to select menu items.
- Press the III button to exit the menu again (EXIT).
Resetting the special functions to the factory settings
1. Press and hold down button III.
2. Then press the UP and DOWN buttons simultaneously.
"FSE" appears in the display.
The soldering station is now reset to the factory settings.
Setting the standby temperature
The standby temperature is automatically set after a temperature
deactivation. The actual temperature flashes in the display.
"STANDBY" appears on the display
(100 °C – 300 °C / 200 °F – 600 °F).
1. Select the menu item STANDBY in Menu 1.
2. Set the setpoint value for the standby temperature with the UP or
DOWN button.
3. Press the I (back) or II (forwards) button to switch to the next
menu item.
Setting temperature deactivation (SETBACK)
When the soldering tool is not in use, the temperature is reduced to
the standby temperature after the set setback time has elapsed. The
setback state is indicated by a flashing actual value and "STANDBY"
appears in the display. Pressing the UP or DOWN button terminates
this setback state. Depending on the tool, the finger switch or the
switching holder deactivates the setback state.
The following setback settings are possible:
 "0 min": setback OFF (factory setting)
 "ON": setback ON (the system is controlled down to standby
temperature with the switching holder after the soldering bit is
stowed)
Navigation
I
II
EXIT III
9-16